WIPER / WASHER: FRONT WIPER MOTOR: INSPECTION (2008 Sequoia)

Last Modified: 11-29-2007		1.6 G
Service Category: Vehicle Exterior	Section: Wiper/Washer
Model Year: 2008	Model: Sequoia	Doc ID: RM000002ZZQ002X
Title: WIPER / WASHER: FRONT WIPER MOTOR: INSPECTION (2008 Sequoia)

INSPECTION

1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY

(a) Check the LO operation.

(1) Connect the positive (+) battery lead to terminal 1 (+1) of the connector and the negative (-) battery lead to terminal 5 (E), and check that the motor operates at low speed (LO).

OK:

Motor operates at low speed (LO).

If the result is not as specified, replace the motor assembly.

(b) Check the HI operation.

(1) Connect the positive (+) battery lead to terminal 4 (+2) of the connector and the negative (-) battery lead to terminal 5 (E), and check that the motor operates at high speed (HI).

OK:

Motor operates at high speed (HI).

If the result is not as specified, replace the motor assembly.

(1) Connect the positive (+) battery lead to terminal 1 (+1) of the connector and the negative (-) battery lead to terminal 5 (E). With the motor operating at low speed (LO), disconnect terminal 1 (+1) to stop the wiper motor operation at any position other than the automatic stop position.

(2) Connect terminals 3 (S) and 1 (+1). Then connect the positive (+) battery lead to terminal 2 (B) of the connector to restart the motor operation at low speed (LO).

(3) Check that the motor stops automatically at the automatic stop position.

OK:

Automatically stops.

If the result is not as specified, replace the motor assembly.